Running a Hydroponic Cannabis System in Thai Heat: Feeding, Reservoir Care, Root Rot, Chillers and Beneficial Microbes (Part 2 of 2)

How well a hydroponic system performs depends on how you run it. This part covers feeding strength by growth stage, pH, reservoir care, root rot, water temperature, water chillers and beneficial microbes. It applies to deep water culture (DWC, where roots hang in aerated nutrient solution), recirculating DWC (RDWC), nutrient film, ebb and flow, drip and aeroponic systems.

Translator’s note: The original’s targets come from cooler climates. Room air in Thailand is often 30–35 °C. Where a target cannot be met without cooling, this part says so and gives practical alternatives. Prices are US prices, and imported equipment will cost a different amount in Thailand.

This is Part 2. Part 1: Hydroponic Cannabis Systems Compared: Deep Water Culture, NFT, Ebb and Flow, Drip, Aeroponics and Kratky (Part 1 of 2)

1. Feeding Strength by Growth Stage

You control feeding strength with EC (electrical conductivity), which shows how much fertiliser is dissolved in the solution. It is measured in mS/cm. Many meters show ppm instead and convert from EC using one of two scales. At 1.0 mS/cm, the same solution reads 500 ppm on one scale and 700 ppm on the other. Check which scale your meter uses before you follow a ppm figure.

Growth stage EC (mS/cm) ppm (500 scale) ppm (700 scale) Notes
Seedling 0.4–0.5 200–250 280–350 Very light feed
Early veg 1.1–1.4 550–700 770–980 Raise every week
Late veg 1.2–1.5 600–750 840–1,050 Full veg strength
Early flower (weeks 1–3) 1.1–1.4 550–700 770–980 Transition feed
Mid to late flower (weeks 4–7) 1.3–1.6 650–800 910–1,120 Peak feed
Ripening (weeks 8–9) 0.8–1.1 400–550 560–770 Lower gradually
Flush 0.0–0.2 0–100 0–140 Plain water or a very light feed

A flush means giving plain water, or a very light feed, at the end of the crop. The forum topic on pre-harvest flushing looks at what it does and does not achieve.

EC ranges listed by brand

The original took these ranges from each brand’s official feed chart (2025–2026). A brand’s place in this table is not a recommendation. Always check the brand’s current chart before you mix.

Brand / line Veg EC Flower EC Notes
General Hydroponics Flora Series (3-part) 1.0–1.4 1.2–1.6 —
Advanced Nutrients pH Perfect (3-part) 1.1–1.4 1.3–1.6 Described as buffering pH to 5.5–6.3 automatically
CANNA Aqua / Coco 1.1–1.4 1.2–1.5 A separate formula for each growing system
Athena Pro (Grow/Bloom/Core) 1.2–1.5 1.3–1.6 —
Jack’s 321 1.0–1.3 1.2–1.5 —

Translator’s note: This forum has not confirmed which of these lines are registered and sold in Thailand. Before you buy any of them, check the Thai registration on the label as explained in the topic on verifying a fertiliser in Thailand. Ask the official Thai distributor. You can also ask other growers in the General Nutrients section.

pH

All hydroponic systems work in the pH range 5.5–6.5. Most nutrients are taken up best at pH 5.8–6.0. Let the pH drift naturally within the 5.5–6.5 range, and correct it only when it moves outside.

What to do: Measure and write down the reservoir’s EC and pH every day. The log shows how fast your solution drifts, so you know how often to adjust it and when to change it.

2. Reservoir Care

Parameter Recommendation
Water change Every 7–14 days
EC of the source water below 0.3 mS/cm; reverse-osmosis (RO) water preferred
Solution volume per plant at least 30–38 L (8–10 US gallons)
Water temperature 18–22 °C
Aeration Continuous; never switch off the air pumps
Light Fully light-proof; no light leaks into the reservoir
Top-up water Plain water, pH-adjusted, with no fertiliser

Reverse-osmosis water has passed through a fine membrane filter that removes almost all dissolved minerals. The 30–38 L per plant figure is larger than the 19 L minimum bucket for DWC. More water per plant means slower changes in temperature and pH.

Translator’s note: Measure the EC of your own tap or well water before you start. If it is above 0.3 mS/cm, use an RO filter or another water source. To keep the air pumps running through power cuts, connect them to a UPS (uninterruptible power supply, a battery unit that keeps power on during a cut). Use opaque tanks and keep them out of the sun. Light lets algae grow in the solution, and sunlight heats it.

What to do: Stand the reservoir in the coolest spot in the room. Wrap or cover it so that no light gets in. This slows warming and algae growth, which are two of the root-rot causes in the next section.

3. Root Rot

Root rot is the most common failure in hydroponic cannabis.

Causes: warm water, low dissolved oxygen and light leaks (light lets algae grow in the solution). Dead plant material in the water and dirty tools also cause it.

Signs: roots turn brown and slimy and smell bad. The plant wilts even though its roots are wet, and growth slows.

Treatment:

  1. Remove dead root material.
  2. Treat with hydrogen peroxide (H2O2) once as a shock: 3 mL of 3% H2O2 per US gallon (about 0.8 mL per litre).
  3. Lower the water temperature to 18–20 °C.
  4. Increase aeration.
  5. Change the whole reservoir.
  6. After the change, add Hydroguard at the label rate to prevent a return.

Hydrogen peroxide kills beneficial microbes (section 6), so it and Hydroguard should not be in the water at the same time. Sources disagree on how long hydrogen peroxide stays active in a reservoir, so add Hydroguard only to the fresh solution after the full change (step 6). Any product you use against root disease must be registered with the Department of Agriculture (กรมวิชาการเกษตร) and used as the label says. The topic on what you may legally spray explains how to check this.

What to do: At every reservoir change, lift one plant and look at and smell the roots. White, firm roots with no smell are healthy. You will catch rot while it is still at step 1 instead of after the plants wilt.

4. Water Temperature

Water temperature Risk level Effect
18–22 °C Safe Best dissolved oxygen, healthy roots
22–24 °C Caution Dissolved oxygen falling; watch closely
24–28 °C High risk Root rot likely without beneficial microbes
above 30 °C Critical Root rot almost certain
below 15 °C Risk Nutrient lockout, slow root activity

Translator’s note: A reservoir with no cooling in a 30–35 °C Thai room sits in the “critical” band. You have five main options. You can cool the whole room with air conditioning, or cool the solution with a chiller (section 5). You can shade and insulate the reservoir and use more water per plant. You can switch to beneficial microbes, which raises the safe limit only from 22 to 24 °C. Or you can move to drip in a growing medium, where the roots are not hanging in the solution. The topic on running hydroponics at a 31 °C reservoir compares these options.

What to do: Put a waterproof minimum–maximum thermometer in the reservoir and record the readings every day for two weeks. The highest reading shows which risk band you are really in and whether you need cooling.

5. Sizing a Water Chiller

A water chiller is a refrigeration unit that cools the nutrient solution. The original’s sizing table comes from Active Aqua, an equipment brand sold by Hydrofarm. The original labelled the power column “BTU”, but the figures are in horsepower (HP), so the column is corrected here. The model names, cooling capacities and reservoir volumes below come from Hydrofarm’s current listings for the Active Aqua Power Boost chillers.

Model (Active Aqua) Power (HP) Cooling capacity (BTU/h) Recommended reservoir volume
AACH10HP 1/10 HP 1,020 38–151 L (10–40 US gal)
AACH25HP 1/4 HP 3,010 151–348 L (40–92 US gal)
AACH50HP 1/2 HP 4,020 341–651 L (90–172 US gal)
AACH100HP 1 HP 10,050 300–950 L (80–250 US gal)

The air temperature around the chiller matters as much as the volume. Manufacturers measure rated performance at a set room temperature, which the manual states. A chiller pushes the heat it takes from the water into the air around it. In hotter air, it cannot cool the water as well as specified.

Translator’s note: An uncooled Thai room at 30–35 °C may be at or above the room temperature at which these ratings are measured, so check that figure in the manual. Place the chiller where its hot exhaust can leave the grow room and where the air it takes in is within its rating. Otherwise the room’s air conditioning has to remove the chiller’s heat as well. Ask the official Thai distributor which model is rated for your actual room temperature. Include the chiller’s electricity cost in your budget.

What to do: During the hot season (March–May), measure the air temperature at the spot where the chiller will stand. Choose the model using that reading, not the average temperature of the room.

6. Beneficial Microbes

A “living” reservoir uses beneficial microbes instead of a sterilizer. The microbes cover the root surface and use up the space and food that disease organisms need. This is called competitive exclusion. The products below are those named in the original.

Product Main organisms When to apply
Hydroguard Bacillus amyloliquefaciens (a beneficial bacterium) Every reservoir fill
Great White Mycorrhizae (fungi that live in partnership with roots), Trichoderma (a beneficial fungus) and bacteria At transplant, then weekly
Mammoth P Bacteria that cycle phosphorus Flowering phase
Recharge Mycorrhizae, Trichoderma and kelp (seaweed) Weekly drench (poured onto the root zone)

Sterile or living reservoir

Feature Sterile reservoir Living reservoir
Sterilizer used H2O2, UC Roots, chlorine None
Beneficials used None Hydroguard, Great White and similar
Water temperature limit Must stay below 22 °C Can handle up to 24 °C
How roots are protected Chemical, kills all organisms Biological, good microbes crowd out bad ones
Maintenance Add sterilizer regularly Add microbes at every reservoir change
Cost Low Medium
Complexity Simple Moderate

Rule: never use beneficial microbes and sterilizers at the same time. H2O2, chlorine and similar oxidizers kill beneficial microbes on contact. Treat UC Roots, which the original lists as a sterilizer, the same way. Choose one approach and stay with it.

Translator’s note: This forum has not confirmed whether Hydroguard, Great White, Mammoth P, Recharge or UC Roots are registered and sold in Thailand. If a product is used against root disease, use it only if it is registered with the Department of Agriculture, and follow the label. Both temperature limits, 22 °C and 24 °C, are below normal Thai room temperature. A living reservoir gives you 2 °C more margin, but you still need cooling. If you cannot find a product, ask the official Thai distributor, or ask other growers in the Indoor Growing section.

What to do: Choose sterile or living, then write the choice on the reservoir lid. Anyone who tops up or treats the tank will then know not to mix the two approaches and kill the microbes.

Thai Legal Note

This article is for education only. In Thailand, cannabis flower is a controlled herb under the Notification of the Ministry of Public Health Re: Controlled Herbs (Cannabis), B.E. 2568. This notification was issued under the Thai Traditional Medicine Protection Act B.E. 2542 and has been in force since 26 June 2025. Flower may only be sold against a PT 33 (ภ.ท. 33) prescription covering at most 30 days. Advertising and online sale of flower are prohibited.

Two Ministerial Regulations of B.E. 2569 followed in 2026. The Ministerial Regulation on Cannabis or Hemp Extracts came into force on 26 April 2026. Licences for extracts above 0.2% THC are granted only to Thai juristic persons that are not “foreign” under the Foreign Business Act B.E. 2542, to state agencies and to the Thai Red Cross Society. The Ministerial Regulation on Controlled Herbs (No. 2) came into force on 30 April 2026 and tightens the licence criteria for cannabis flower.

Selling, processing or exporting cannabis flower requires a licence. Doing so without one can be punished with up to 1 year in prison and/or a fine of up to 20,000 baht (Section 78 of the 1999 Act). The GACP topic explains the Good Agricultural and Collection Practice standard and the records it requires for cultivation. PT 33 is the prescription form for dispensing flower; it is not a cultivation permit.

Growers must follow all applicable rules on plant numbers, THC limits, record-keeping and reporting. The draft Cannabis Control Act is not yet law: the Cabinet approved the draft on 22 September 2026 and sent it to the House. Use pesticides only if they are registered with the Department of Agriculture, and follow the label. This forum does not encourage or help with any activity that breaks the law of Thailand or any other country.

References

  1. Resh, H.M. (2022). Hydroponic Food Production (8th ed.). CRC Press.
  2. Langenfeld, N.J., Pinto, D.F., Faust, J.E., Heins, R., & Bugbee, B. (2022). “Principles of Nutrient and Water Management for Indoor Agriculture.” Sustainability, 14(16), 10204.
  3. Active Aqua / Hydrofarm (2025). Equipment Specifications & Sizing Guides.
  4. General Hydroponics / Advanced Nutrients / CANNA — Official Feed Charts (2025–2026).

Post your reservoir temperatures, EC logs or root-rot problems from Thai grow rooms below this topic. Other growers can then compare them with their own figures.