What Is Water Potential? The Pressure That Decides Where Water Flows

Water potential is a measure of the energy of water in a medium, a root or a leaf, compared with pure water. Water always moves from a place of higher water potential to a place of lower water potential.

The units and the sign

Water potential is written with the Greek letter psi (Ψ) and measured in megapascals (MPa). The OpenStax Biology textbook explains that pure water is set at zero by definition. Water in soil, roots and leaves usually has a negative value. The more negative the number, the harder that water is to pull away.

What lowers it

Four parts add up to the total:

  • Solutes: dissolved salts and sugars lower water potential. In the cytoplasm of plant cells, this part typically sits at −0.5 to −1.0 MPa.
  • Pressure: turgor pressure in living cells raises it, while tension in the xylem lowers it.
  • Matrix: water clinging to surfaces, such as soil particles or cell walls, has a lower potential. In a dry seed this can reach −2 MPa.
  • Gravity: lifting water upward costs about 0.1 MPa for every metre of height.

Why growers should care

Roots draw water only while the medium’s water potential stays above the root’s. As a medium dries, it holds its last water more tightly. Salt in the root zone has a similar effect, because solutes lower the potential of the water around the roots.

Cornell University’s study guide for crop advisers gives typical values for soils. Field capacity sits at about −0.1 to −0.33 bar. The permanent wilting point sits at about −15 bar, which equals −1.5 MPa.

The field capacity page covers how much water a medium holds after draining. This page explains the force that decides whether that water can reach the roots.

Common mistakes

  • Assuming a wet pot always means water for the plant. A salty root zone makes water harder to take up. Check runoff EC as well as pot weight.
  • Mixing up units. One megapascal equals 10 bar or 1,000 kilopascals. Note which unit your sensor or chart uses.
  • Waiting for wilting before watering. Cornell notes that most crops wilt at about −2 to −5 bar, well before the permanent wilting point. Water on a planned dryback instead.

This week, record runoff EC next to pot weight, so you can tell a dry root zone from a salty one.

Related terms

field-capacity · Permanent Wilting Point · Tensiometer · salt-buildup · transpiration · xylem-and-phloem · water-holding-capacity

Read more on Asiannabis

References